Using the autopilot is simple, but requires prior guidance: you must click on the desired function before you start typing. Use the ENT buttons to confirm what you have typed or CLR to delete and type again. It is always necessary to click on the desired function before typing.

Consider starting to configure the autopilot by selecting the altitude; therefore, first press the ALT button and then enter the desired value. Press ENT if the final value has fewer than 4 digits. Above 5 digits, the value is automatically applied by the autopilot. Next, set the desired speed or heading, or even the GPS navigation mode. If you want to remove speed control, click the A/T button. Consider using the VS+ and VS- buttons to interact with the climb mode.

​

IMPORTANT: Avoid using Mach control during climbs to prevent constant acceleration and deceleration. During the climb phase, if you wish to use automatic airspeed control (A/T), use normal airspeed control in knots, and after stabilizing your altitude, switch to Mach control if desired.